What is a structural alteration?
A structural alteration changes how a house carries its loads, most often by removing a load-bearing wall and replacing it with a steel beam. It is how kitchens and dining rooms become open-plan, and how extensions are joined to the original house.
How much does a structural alteration cost in Maldon?
In Maldon, a structural alteration typically costs £4,750–£10,000 for a typical knock-through with steel beam, including VAT at 20% (standard rate). We start from a UK-wide guide and adjust it for the East of England, where labour and materials are typically about 6% above average. Design, structural calculations and council fees are extra.
| Size or type | Guide range |
|---|---|
| A typical knock-through with steel beam | £4,750–£10,000 |
| Higher specification | £10,000–£12,500 |
The biggest cost drivers are:
- Party wall involvement
- Floor and ceiling repairs
- Flush or downstand beam
- What sits above the wall
For a figure based on your own measurements, try the guide price tool, then book a free home visit for a fixed quote.
Do you need planning permission for a structural alteration in Maldon?
Whether you need planning permission depends on your house and its location in England. In England removing a load-bearing wall does not need planning permission but does need building regulations approval with an engineer’s calculations. If the beam bears on a party wall, a party wall notice must be served.
Building regulations approval comes from the council’s building control service or a registered building control approver. The work is inspected at key stages, such as foundations, drainage and insulation, and a completion certificate is issued at the end.
We check this for your address before design work starts, so there are no surprises later.
What we handle
Handled as part of most structural alterations:
- Steel beam supply and installation on padstones
- Making good, plastering and flooring repairs
- Fire protection to the steel
- Temporary propping
- Building control sign-off
- Building control application
How long does it take?
The build itself usually takes 1 to 2 weeks on site for a typical knock-through. Allow time beforehand for drawings and approvals, usually 6 to 12 weeks.
Building in Maldon
Many towns in the East of England have estates built since the 1970s, where garage conversions and rear extensions are popular.
Maldon sits in Essex, about 9 miles east of Chelmsford. We cover the whole of Maldon, including postcodes CM9.
How it works
- 01
Visit and measured survey
A free visit to understand the project, check access and take measurements.
- 02
Design and pricing
Design options, then a fixed quote based on the chosen drawings and specification.
- 03
Approvals in place
We handle planning, building control and neighbour notices before work starts.
- 04
Build and sign-off
We run the build to a written programme and hand over the completion certificate.
Questions about structural alterations in Maldon
How do I know if a wall is load-bearing?
Only a survey can confirm it. Walls that carry floor joists, roof loads or walls above are load-bearing. We check on site and the engineer confirms.
Do you build structural alterations in Maldon?
Yes. We build structural alterations across Maldon, including postcodes CM9. Every project starts with a free home visit.
Do I need building regulations approval?
Yes. Removing a load-bearing wall is building work that needs approval, with calculations for the beam.
How much does a structural alteration cost in Maldon?
In Maldon, a structural alteration typically costs £4,750–£10,000 for a typical knock-through with steel beam, including VAT at 20% (standard rate). Your fixed price depends on the survey and drawings.
How long does a knock-through take?
Usually 1 to 2 weeks on site, plus a few days for plastering to dry.